Combo Bionic Robot Handmade - Teknoloji Dünyası

Required Parts:

1 Piece Combo Bionic - Robot Handheld 3D Output Parts

11 Piece SG90 RC Servo Motor with 180 °

Bolt Assembly Required for Installation

Screwdriver Set

Note: When we buy Combo Bionic - Robot Hand Set, we will first need to group the parts with 3D output.

Note: The SG90 RC Servo Motor included in the set should not try to turn 180 ° motors by hand. Otherwise, you may damage the motor gears.

Step-1 As the first step, we start with finger assembly:

Note: You will need to assemble the thumb at the last stage. First, Mount the other 4 fingers.

Tighten the M3 * 20mm screws included in the kit to mount the fingers. Do not tighten the screws to the end, tighten them to allow the parts to turn (parts may rotate, but slight friction may occur). You can use the screws that come from inside the motor package to place the motors in their slots.

After Mounting the Finger You will need to check that the fingers and joints move freely before connecting the motor. If there is no problem in finger and joint movements, you can perform motor assembly.

Step-2 Fingering the Body

Fingers and Joints Completed Assembly should be placed on the body at this stage. Figure - Inserting the Finger Part in the Area Shown with Red Bolt in the Middle in 03 and Screwing it from the Bottom to the Fingers. Here you will need to screw in the six flat joints.

Step-3 Mounting the thumb to the body

For the assembly of the thumb, first we start with the fingers like the first assembly. Then, After Mounting the Second Joint Region, Perform the Assembly of the Cylinder Part to Ensure the Content of the Finger to Rotate Correctly and Place the Screw Under the Index Finger of the Robot Hand. Then Connect to the Motor Mounted Inside the Body.

Step-4 Mounting the Upper Body

After completing the thumb assembly, we assemble to the lower body as shown in Figure 7 and Figure 8 with a red bolt.

Step-5 Substrate Installation

In the last step, we will carry out the assembly of the lower table that will keep our robot hand up. We are assembling with 3 screws to the upper body of the robot hand from inside the lower table.

When you complete the installation process, you need to make the adjustment to the engine code. While making this adjustment, remove the motor connections and adjust the exact position of the motor, make the motor connections and install the code.

Combo Bionic - Robot Hand Product Options are as follows.

Combo Biyonik – Robot El Kiti İncelemek İçin Tıklayınız

Combo Biyonik – Robot El 3D Çıktı Parçaları İncelemek İçin Tıklayınız